By using our website, you agree to the use of our cookies.
01925 812809 Unit 19 Riverside Ind Est, Woolston, Warrington, WA1 4BA Mon-Friday 8am-4.30pm Closed Sats for time being *Christmas close 17/12 (4.30 pm) Re-open Mon 04/01/21

Shop

UPOL Reface- Polyester Spray Filler

£18.80

How To Order

REFACE is a highly effective two component spray filler for the preparation of irregular steel and glass fibre surfaces. REFACE gives a very high build, adheres excellently to steel, is easy to sand and is the ideal base for most paint systems..

SKU: 8540 Categories:,

Product Description

Surface preparation and instructions for use

Reface can be applied to the following surfaces:-

Polyester fillers.

Old sound paint surfaces (with the exception of thermoplastic acrylics).

* Note: Reface is not recommended for use over Aluminium, Galvanized (Zinc coated) or etch primers.

Degrease with Precleaner or panel prep and allow to dry. E.g. S2000, S2001 or S2002. Abrade with 80 grade paper for bare steel or 240 grade for painted surfaces. Re-clean and dry.

Hardener

Mix Reface and hardener thoroughly. Add hardener at 5 parts per 100 by volume or 3% by weight.

Only mix amount required for immediate work. Never return unused mixed product to the can.

Health and Safety Statement

FOR PROFESSIONAL USE ONLY. Read full instructions before use.

IMPORTANT: This product contains hazardous materials and therefore appropriate personal protective equipment should always be used. Please refer to the label and consult the material safety data sheet for full handling instructions and personal protection information. These are available via your local stockist or via the U-POL website at WWW.U-POL.COM. U-POL disclaim any liability where the user does not wear the recommended personal protective equipment.

Application

Stir well before use. Minimum recommended working temperature is 15ºC. Application with a gravity fed gun is preferable e.g. U-POL GUNGHV20, though a suction gun will suffice. Use a 2mm-3mm fluid tip. Hold gun 15-20cm from the panel. Layers may be built up wet-on-wet, but 5-10mins between coats is recommended.

Pot Life

45 – 60 mins at 20°C

Build and Pressure

2-3 coats will give a very high build. Each pass will give a build of approximately 75-100 microns.

A pressure of 3-3.5 BAR is required at the gun.

Drying Time

2-3 hours at 20ºC or 30 mins. at 60ºC.

Drying time is dependent upon film thickness, humidity and temperature.

Overpainting

Wet or dry flat, clean and dry thoroughly, Reface may then be overcoated with most primers and paint systems. A non sanding sealer is necessary if used in damp climatic conditions.

VOC Information

The EU limit for this product (product category: IIBc) in ready to use form is 540g/litre.

The VOC content of this product in ready to use form is 200g/litre

Data Sheets

Technical Data Sheet (TDS)
Technical Data Sheet (TDS)
Material Safety Data Sheet (MSDS)
Material Safety Data Sheet (MSDS)
WordPress Theme built by Shufflehound. Copyright (c)  GRP[UK] LTD 2017 - All Rights Reserved - Web Design and Hosting by TADAH